4. Disconnect the chain brake connector and put the
cable to the side.
5. Remove the screws and the chain brake cover.
6. Steer the large spring onto a screwdriver and
remove the spring.
7. Remove the spring and the shaft (B), and then the
clamp (C).
5.19.2 To assemble the chain brake
WARNING: Use protective goggles. Springs
can eject and cause injury.
1. Lubricate the parts.
2. Put the spring and shaft (B) in the crankcase with
the heel in its groove.
3. Put the clamp (C) in the crankcase.
4. Compress the large spring (A) and put it in its
groove.
5. Attach the chain brake cover.
6. Connect the sensor plug for the hand guard and put
the cable in its holder.
539 - 003 - 05.12.2018 Repair instructions - 19
To Next Page
Loading...
