T540i XP T540i XPG
Vibration levels
3
Front handle m/s
2
2.2 2.2
Rear handle m/s
2
4.3 4.3
Equivalent vibration levels
4
Front handle m/s
2
2.1 2.1
Rear handle m/s
2
3.5 3.5
Saw chain/guide bar
Recommended bar lengths, inch/cm 12-16/30-40 12-16/30-40
Usable cutting length, inch/cm 11-15/28-38 11-15/28-38
Type of drive sprocket/number of teeth m0.325"/7 (SP21G), 1/4"/8
(H00)
m0.325"/7 (SP21G), 1/4"/8
(H00)
Maximum chain speed / (savE), m/s 24 (18) 24 (18)
Radio frequency data for Bluetooth
®
Frequency band, GHz 2.4-2.4835 2.4-2.4835
Output power, max dBm 0 0 0
Accessories
Guide bar and saw chain combinations
WARNING: Use the BLi200X battery
when you use the saw chain SP11G.
The following cutting attachments are approved for
Husqvarna T540i XP.
Guide bar Saw chain
Length, in Chain pitch, in Gauge, mm Max. nose ra-
dius
Type Length, drive
links (no.)
Low kickback
12 0.325 mini 1.1 8T Husqvarna
SP21G
51 Yes
14 59
16 64
3
Vibration level, according to EN 62841-4-1. Reported data for vibration level has a typical statistical dispersion
(standard deviation) of 1 m/s
2
. Declared vibration data from measurements when the machine is fitted with a
bar length and recommended chain type. If the machine is fitted with a different bar length, the vibration level
may vary by max ± 1.5 m/s
2
.
4
Equivalent vibration level is measured and calculated as for combustion engine powered chainsaws. These
figures are quoted to be able to compare vibration data regardless of type of engine according to ISO
22867:2011.
1036 - 009 - 01.03.2023 29
To Next Page
Loading...
