Problem Cause Action
There is loss of power. The product is operated at too high
forward or rearward speed when
you cut grass.
Use slower speed.
The throttle control is in the choke
position.
Put the throttle control in the fast
position.
There is build-up of grass, leaves
or unwanted material under the
cutting deck.
Clean the cutting deck.
The air filter is dirty. Clean or replace the air filter.
The engine oil level is too low. Do a check of the engine oil level.
Fill with engine oil if it is necessa-
ry.
The engine oil is dirty. Replace the engine oil.
The spark plug is defective. Replace the spark plug.
The fuel filter is dirty. Replace the fuel filter.
The fuel in the fuel tank is bad. Replace the fuel in the fuel tank.
There is water in the fuel. Remove all fuel from the fuel tank
and the carburetor. Fill the fuel
tank with new fuel and replace the
fuel filter.
The spark plug wire is loose. Connect and tighten the spark plug
wire.
The air intake or the cooling fins
on the engine are blocked.
Clean the air intake and the cool-
ing fins on the engine.
The muffler is clogged or dam-
aged.
Clean or replace the muffler.
There is loose or damaged wiring. Do a check of all wiring.
The engine valves are not adjus-
ted correctly.
Speak to an approved service
agent.
There is vibration in the product. The blades are loose. Tighten bolts on the blades.
One or more of the blades are
damaged or not balanced.
Balance the blades or replace the
blades.
The engine is loose. Tighten the engine bolts.
The battery does not charge. The main fuse is defective. Replace the main fuse.
The battery is defective. Replace the battery.
The charging cable is disconnec-
ted.
Connect the charging cable.
The connection at the cable con-
nectors on the battery terminals is
bad.
Do a check of the battery connec-
tions.
36 2010 - 003 - 10.04.2023
To Next Page
Loading...
Need help?
General
