Problem Cause Action
The product moves slowly, with ir-
regular speed or not at all.
The product is in freewheel mode. Pull out the freewheel control lev-
er. Refer to
To put the product in
freewheel mode on page 20
.
The parking brake is engaged. Disengage the parking brake.
The drive belt is loose or dam-
aged.
Replace drive belt.
There is air in the transmission. Remove the air from the transmis-
sion. Refer to
To remove the air
from the transmission on page 33
.
There is unwanted materials on
the steering plate (if the steering
plate is installed).
Clean the product.
The square key on the axle is
missing.
Install the square key. Refer to
To
repair the tires on page 25
.
The cutting result is unsatisfactory. The blades are blunt or damaged. Sharpen the blades or replace the
blades.
The cutting deck is not parallel. Adjust the parallelism of the cutting
deck. Refer to
To adjust the paral-
lelism of the cutting deck on page
29
.
The grass is wet. Let the grass become dry before
you cut it.
The grass is long. Start with a high cutting height and
decrease it gradually.
The tire pressure is incorrect. Do a check of the tire pressure.
Adjust the tire pressure if it is nec-
essary.
The product is operated at too high
forward or rearward speed.
Use slower speed.
The drive belt for the cutting deck
is worn or damaged.
Replace the drive belt for the cut-
ting deck.
The engine backfires when the en-
gine stops.
The throttle control is not put in the
slow position.
Refer to
To stop the product on
page 18
.
The engine stops when you try to
reverse.
The reverse operation system
(ROS) is not engaged.
Engage the reverse operation sys-
tem (ROS). Refer to
To use the re-
verse operation system (ROS) on
page 19
.
Transportation, storage and disposal
Transportation
Note: Close and attach the hood to the product
during transportation to prevent damage. Connect
the hood to the product with the correct tools (rope,
cord and so on).
When you move the product, put the freewheel
control in freewheeling position to disengage the
38 2010 - 003 - 10.04.2023
To Next Page
Loading...
Need help?
General
