EasyManua.ls Logo

Husqvarna V 548 - LUBRICATION - Hydraulic System Maintenance; Transaxle Fluid Change

Husqvarna V 548
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Transaxle Fluid Change
Hydraulic Oil Level Check
Check the oil level in the hydraulic tanks daily
before using the mower. The oil level should be
between the markings on the dipstick. This is the
appropriate level when COLD.
Check all connections, hoses, and tubes for
damage or leaks. Contact an authorized service
workshop if repair or replacement is needed.
Oil and Filters Change
The hydraulic oil and lters must be replaced
every 250 to 1000 hours or once per year,
depending on the type of oil used. See Qualied
Hydraulic Oils in the Lubrication section for a
list of approved oils or refer to the transmission
manufacturers service manual.
Due to the risk of impurities entering the system,
all transmission work should be performed by an
authorized service workshop.
WARNING! Escaping hydraulic oil
under pressure can have sufcient force to
penetrate the skin, causing serious injury. If
injured by escaping uid, see a doctor at once.
Serious infection or reaction can develop if
proper medical treatment is not administered
immediately.
IMPORTANT INFORMATION Use minimal
lubrication and remove excess lubricant so that
is does not come into contact with belts or belt
pulley drive surfaces.
29
LUBRICATION

Related product manuals