P/N 3113125_A 4-3
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
MNGSC8-A Self Contained Merchandisers
CLEANING STAINLESS STEEL SURFACES
Use non-abrasive cleaning materials, and
always polish with grain of the steel. Use warm
water or add a mild detergent to the water and
apply with a cloth. Always wipe rails dry after
wetting.
Use alkaline chlorinated or non-chlorine
containing cleaners such as window cleaners
and mild detergents. Do not use cleaners
containing salts as this may cause pitting and
rusting of the stainless steel finish. Do not use
bleach.
CLEANING CONDENSER AIR FILTER
Condenser filters should be cleaned once
per month or depending on the amount of
dust and dirt accumulation in the operating
environment. A dirty condenser blocks normal
airflow through the coils.
Airflow blockage increases energy consumption
and reduces the merchandiser’s ability to
maintain operating temperature.
1. Vacuum the condenser air filter.
Unplug the unit, and remove the filter.
Vacuum the filter with a hose attachment to
remove any debris. If dirt buildup cannot be
removed with the vacuum, the filter should
be washed.
2. Wash the condenser air filter.
Soak the filter in water and vinegar for an
hour and rinse with water. Do not rinse
with high water pressure. Let the filter dry
and replace it in the cabinet.
3. Replacing worn air filters.
Check for damage by inspecting the filter
for tears or holes or excessive deposits
of dirt that will not wash off. If any of
these signs are present, it is time to replace
the air filter. Contact your Hussmann
representative to purchase new air filters.
DO NOT FLOOD!
Use only enough water necessary to clean
surface. Water must not drip down the case!
Never use ammonia based cleansers, abrasive
cleansers, or scouring pads.
Wear Safety Glasses and Gloves
to perform this maintenance.
Condenser
Air Filter
(Slide to
remove)
To Next Page