WiFi Info section
• WiFi modem state
- Disable – Wifi is disabled.
- Wait for power on – Waits for WiFi module when power on.
- Init – Initializing of WiFi module.
- Connecting – Connecting.
- SSID check – SSID check.
- Connected – Connected to selected WiFi network.
- Network WiFi scan – Scan of available WiFi networks.
- Wait for scan – Waits for Network WiFi scan.
• Current SSID – Current name of the network to which the device is connected. If the
parameter is missing, the device is not connected to any WiFi network.
• Current BSSID – Current identifier of the WiFi network connection point. If the
parameter is missing, the device is not connected to any WiFi network.
• Current RSSI – Relative strength of signal input. The lower the RSSI, the stronger the
signal.
• Signal Quality – Strength of WiFi signal in % with graphic indicator.
• Current Channel – WiFi channel on which the device communicates. If the parameter is
missing, the device is not connected to any WiFi network.
WiFi Setup section
• WiFi Enable – Enable or disable WiFi. By standard, the wireless interface is disabled.
Device restart follows enabling.
• SSID – Name of the WiFi network to which should be the device connected. If you do not
know your network name, use the Scan AP function at the bottom of the page.
• Password – Secured network password. If you do not know it, contact your network
administrator.
• BSSID – Identifier of the WiFi network connection point (MAC address of the connection
point). Optional data.
To Next Page
Loading...