Network IPv4 section
WiFi network parameters. Only the wireless interface is set here. Configure RJ45 LAN
parameters on the General Setup tab.
• DHCP - Enables the IP address setting function of the DHCP server, if available. Enabling
or disabling DHCP depends on the needs of the user and the network administrator.
• IP Address - The IP address of the device, assigned by the network administrator.
• Network Mask - Network mask, assigned by the network administrator.
• Gateway - IP address of the default gateway, assigned by the network administrator.
• DNS Primary / DNS Secondary - IP address of the DNS server, assigned by the
network administrator.
Wifi Scan List section
• SSID - Name of the WiFi network found.
• BSSID - Connection point identifier (MAC address).
• Channel - The WiFi channel where the AP communicates.
• Security - The security type of WiFi communication.
• Signal - WiFi signal strength in % with graphical indicator.
Connecting to a discovered WiFi
• Click on the SSID of the discovered network to pre-fill the WiFi settings and then just fill
in the Password. The BSSID field will remain blank. Standard settings. When you change
the AP, it will reconnect itself.
• Clicking on the BSSID will pre-fill not only the network name (SSID) but also the MAC
address of the specific AP (BSSID). The device will then connect to that AP and in the
case of pooled networks will not try to reconnect.
To Next Page
Loading...