The unit has a built-in battery that can retain the time for several days if the power is
switched off to the unit. If the unit is off for longer periods the day & time may need to
be reset upon next start up.
Setting the target temperature
•
To set the target temperature of the heater use the UP/DOWN buttons to cycle to the
desired value and press the OK button to confirm.
Switching between Full/Half power
•
Press the full/half power select button to toggle between the settings. The current
setting will be displayed by either the “LO” or “HI” icon on the display.
Switching between Manual/Auto operation
•
Press the manual/auto select button to toggle between the settings. The current
setting will be displayed by either the “M” or “A” icon on the display.
Setting the child lock
•
Press the UP & DOWN buttons simultaneously and hold until a beep sounds.
The target temperature display will be replaced by “[ ]” icon to indicate the
panel is locked.
•
Repeat the first step to unlock the heater.
Manual operation
The most basic setting of the heater allows the user to control when the heater is active
by simply switching between on/off via the standby button. However, it is strongly
recommended to consider setting a timed operation by using the ‘automatic operation
mode’ where anticipated usage is predictable, to avoid energy wastage.
•
Select the manual operation mode by pressing the manual/auto (M/A) select button.
To confirm the selection check that the “M” icon is displayed.
•
The heater will maintain the temperature displayed unless switched off or placed
into standby mode.
Manual operation (auto power off mode)
Whilst the heater is running in manual mode it is possible to control the length of time
the heater will operate for using a basic timer function. Using this you can select the
desired time for the heater to switch off. This feature helps to ensure the heater is not
turned on and forgotten about.
7
To Next Page
Loading...
