•
Select the automatic operation mode by pressing the manual/auto (M/A) select
button. To confirm the selection check that the “A” icon is displayed.
•
Press the SET select button to enter the 24/7 timer programming screen.
•
The day setting will flash on the display. Use the UP/ DOWN select buttons to move
between the available days and press the SET select button to confirm when the
desired day to be programmed is flashing.
•
The time display will now show a flashing hour setting, this is the hour at which the
heater will automatically switch on (note it is only possible to set the timer to full
hours, minutes cannot be set). Use the UP/DOWN select buttons to choose the
desired hour to switch on and press the SET select button to confirm.
•
The second option to be set on the time display will now flash, this is the hour at
which heater will automatically switch off. Use the UP/DOWN select buttons to
choose the desired hour to switch off and press the SET select button to confirm.
•
The time display will now move to the next schedule you can create (shown by area
‘3’ on the annotated image) and the previous steps for setting the switch on and off
hours should be followed.
•
Up to 4 individual start stop times can be specified for each day but it is possible to
exit and store the schedules once the desired number of operations have been set,
simply press the OK select button at any time to store and exit the scheduling feature.
•
Repeat all steps for each day of the week where timed operation is required. The
default for each day and period of operation is off so it is not necessary to enter any
days that are not required.
When the heater is in a defined period of non-operation it will automatically go into
standby mode. It can be woken up in order to alter any settings by pressing the standby
on/off button but will go back into standby if no settings are changed within 10 seconds.
If you want to switch the heater on outside of the usual, programmed user set schedules
you will need to override the automatic operation mode. This can be done by pressing
the standby on/off button under the LED indicator to turn the heater on. You will then
need to select the manual operation mode by pressing the manual/auto (M/A) select
button. To confirm the selection check that the “M” icon is displayed. This is the most
To Next Page
Loading...
