5--4
34
Use and maintenance manual S-- 20DS
Rapid vice positioning
By means of a simple device the vice can be slid back and forth to accelerate vice
opening and closing operations.
" Grip the lever illustrated in the figure below and rotate in a clockwise direc-
tion: the vice is now free to slide back and forth to the required position. On-
ce positioned, release the lever to lock the vice in place.
" Finally, position the vice to within 2÷3 mm of the workpiece using the han-
dwheel.
Rapid vice translation
Thevicecanbemovedtotheleftortotherightinordertocarryoutangledcuts,
by sliding it along the straight guides.
" Release the blocking ball grip indicated in the figure;
" Position the vice on the left or on the right and tighten the blocking ball grip;
To Next Page
