Error messages / troubleshooting
FAM 25/45/60/75/95
en(us)
Page 129/160
BEWA FAM25-95 3402054f en(us) 2013-06-13 2013-06-13
16. No defined value from CS
Cause: The charge pump for the CS runs for 2 minutes in Automatic
mode.
The CS has been reporting "no measured value from CS" for
4 minutes.
The message is shown on the CS display. The FAM
continues to run. The CS is switched off for 15 seconds, after
which a new measurement is started.
Remedy: If the measurement has failed 3 times in the "Filter to"
operating mode, then the message "Start screen, RH+P, T
and CS" will appear on the display.
To Next Page
Loading...
Need help?
General
