FOR BEST RESULTS, READ EACH STEP IN ITS ENTIRELY BEFORE PROCEEDING WITH STEP.
1. Prepare The Hot Tub For Filling
Clear all debris from the hot tub.
Remove filter lid. Place the end of your garden hose into the empty weir filter and begin
filling with clean water.
Note: Never fill with water from a water softener. If your water is extremely "hard", it is
preferable to fill half way with hard water and the rest of the way with softener water. Or, you
may fill entirely with hard water if you use special water additive available from your dealer.
Fill hot tub until water level is 3" above of bottom of filter housing. See Fig. 6, 7.
Do not overfill.
Note: Always fill your spa through the filter bucket. See Fig 7. Failure to do so may cause air to be
trapped in circulation pump, preventing the pump from circulating water.
Remove the hose and re-install lid
2. Turn on power to hot tub at the home circuit breaker GFCI. The GFCI circuit breaker must
be tested before each use of your spa. Press the “TEST” button on the breaker, the circuit
breaker should go to the tripped positon. Reset the GFCI and ensure it stays set.
The heater and circulation pump will automatically activate. Ozone will be on. One minute after start
up blower purges for 30 seconds and pump 1 and pump 2 purge for one minute.
3. Add Start-Up Chemical as recommended by your dealer. Refer to Page 19 for general
guidance.
4. Place Cover On Hot Tub
Keeping the insulating cover in place anytime the hot tub is not in use will reduce the
time for heating, thereby minimizing operating costs.
The time required for initial heat-up will vary depending on the starting water tempera-
ture.
11
START-UP INSTRUCTIONS - HS200 CONTROL
Figure 6
Figure 7
Water Level 3”
Above Bottom Of
Filter Housing
Air Control
Air Control
Aromatherapy
Spa Side Control
Filter Lid & Cup Holder
Water On/Off
Valve
Pillow
Air ControlAir Control
water Fall
Aux Control
Air Control
Pillow
Jets
Filter Bucket
Skimmer Float
Assembly and
Basket
Filter Cartridge
To Next Page
Loading...