1
Read and follow all instructions carefully
When installing and using this electrical equipment, basic safety precautions should always be fol-
lowed, including:
WARNING SIGN MUST BE POSTED
The Warning sign (RED) is packed with your
new Hydro Spa. This sign must be posted in a
prominent place in close proximity to the spa
installation site immediately upon completion of
spa installation.
WARNING: To reduce the risk of injury, do not permit children to use this product unless they
are closely supervised at all times.
WARNING: A grounding wire connector is provided on this unit to connect a minimum No. 8
AWG (8.4mm2) solid copper conductor between this unit and any metal equipment, metal
enclosures of electrical equipment, metal water pipe, or conduit within 5 feet (1.5m) of the
unit.
DANGER: Risk of Accidental Drowning. Extreme caution must be exercised to prevent unau
thorized access by children. To avoid accidents, ensure that children cannot use a spa or hot
tub unless they are supervised at all times. Cover spa and use safety locks to prevent acci
dents.
DANGER: Risk of Injury. The suction fittings in this hot tub are sized to match the specific
water flow created by pumps. Should the need arise to replace the suction fittings or the
pump, be sure that the flow rates are compatible. Never operate the hot tub if the suction fit
ting is broken or missing. Never replace a suction fitting with one rated less than the flow rate
marked on the original suction fitting.
DANGER: Risk of Electric Shock. Install at least 5 feet (1.5m) from all metal surfaces. As an
alternative, a hot tub may be installed within 5 feet of metal surfaces if each metal surface is
permanently connected (bonded) by a minimum No. 8 AWG (8.4mm2) solid copper conductor
attached to the wire connector on the grounding lug, inside the equipment compartment on
the equipment box.
DANGER: Risk of Electric Shock. Do not permit any electrical appliance, such as a light, tele
phone, radio, television, etc. within 5 feet (1.5m) of a hot tub unless such appliance are built-
in by the manufacturer.
ELECTRICAL SUPPLY: The electrical supply for this product must include a suitable rated
switch or circuit breaker to open all ungrounded supply conductors to comply with section
422-20 of the National Electrical Code, ANSI/NFPA 70. The disconnect must be readily acces
sible and visible to the hot tub occupant but installed at least 5 feet (1.5m) from the hot tub
water.
IMPORTANT SAFETY INSTRUCTIONS
To Next Page
Loading...