pump constantly draws water from the spa, runs it through the filters and the heater,
then back through return jets to the spa. The ozone output is on whenever the circula-
ion pump is running. Twice per day the pumps and blower (if equipped) turn on to pre
vent the spa water from becoming stagnant in plumbing lines of therapy jets and blower
lines when the spa used very little and improves the skimmer action to remove debris
and suspensions from the water surface, twice per day at the start of every filter cycle
the blower purges all air lines for 30 seconds and pumps purge all plumbing lines and
agitate water for 5 minutes. In a 24 hour circulation system the "filtration cycle" pro
gram operates only on limited base. In Economy mode, when actual water temperature
of the spa is below the set temperature the heater will turn on only during the filtration
cycle. In "Sleep" mode when actual water temperature of the spa is 20°F below the set
temperature the heater will turn on only during the filtration cycle.
Heater
Your spa is equipped with an electrical heater. By setting your thermostat to the desired
temperature, your heater will automatically turn on and off as needed. The temperature
set point ( set temperature) can be adjusted from 80°F to 104°F/26°C-40°C). To raise
the set temperature press the "Warm" button. To lower the set temperature, press the
"Cool" button. The start up temperature is set at 100°F/37.5°C.
"Simplified freeze protection"
If a freeze condition is detected (temperature of heater enclosure is less than 44° F, the
pump(s) are automatically activated until the temperature of heater enclosure reaches
45° F. The freeze protection is enabled regardless of the spa mode.
2. Air Volume Control
Your spa is equipped with Air Volume Controls. Each jet system has its own air control. These con-
trols allow you to regulate the amount of air which is mixed with the water entering through the jets.
Counterclockwise rotation adds more air and clockwise rotation reduces air flow. To minimize heat
loss, these controls should be closed when the hot tub is not in use.
3. Waterfall control
Turn the waterfall valve clockwise to decrease or turn off waterfall output. It takes four full revolutions
to change the waterfall from full off to a full on flow rate.
4. Adjusting Jets
All jets in your new spa can be adjusted for high and low impact massage, providing an ultimate
massage. Each jet has its own water volume and directional or oscillating flow adjustment.
To adjust jets:
Turn outer dial counterclockwise to increase water volume. Turn outer dial clockwise to decrease
water volume or to shut jet off.
For adjustment of the directional jets move the nozzle of jet to any angle.
5. Aromatherapy
Simply remove the Aromatherapy injector cap, drop in injector basket your favorite scented beads.
When the Air blower is activated, the scent will be released into vapor through the air injectors of
your spa. See your dealer for replacement of scented beads.
OPERATING INSTRUCTIONS - HS200 M7
20
To Next Page
Loading...