Hydropool Serenity 45L - Filling, Checking, and Starting Your Hot Tub; Hot Tub Filling Procedure; Pre-Start Checking; Initial Start-Up Sequence

16
FILLING, CHECKING AND STARTING YOUR HOT TUB
FILLING
· When adding water for the first me, the hot tub
should be filled through the skimmer opening (helps
to prevent air locks) using a standard garden hose,
turning the tap on slowly to prevent damage to the
surface by a jerking hose connecon.
· Ensure the handles on the intake and return gate
valves are pulled up and stem locks are in place.
· Ensure the drain hose-bib is closed.
· Ensure that all jets are open.
· Fill the hot tub to the recommended level,
approximately 4 inches above the top of the
skimmer opening.
CHECKING
· Although your hot tub was thoroughly water-tested
in the factory, some loosening of fings can occur
during shipping. Before any decking, ling or
carpeng is completed around the installaon, fill
and operate your hot tub to test for leaks (this
ensures easy access and inexpensive correcon).
Check all union connecons and plumbing for minor
leaks. In the event of a leak, ensure all union
connecons and pump plugs are ght and all
o-rings/gaskets are in place.
STARTING
· Before applying voltage to power-up your hot tub, it
is very important that you understand the sequence
of events that occur when the system is acvated in
order that the pump can be primed efficiently and
damage to the system can be avoided.
· Turn the main power “on” at your electrical panel.
· Follow the control instrucons for your parcular
model hot tub to put the pump into low speed see
secon HYDROPOOL CONTROL SYSTEMS PUMP
PRIMING/RELEASING AN AIR LOCK
· On some systems a message will appear on the
display indicang that the system is in PUMP
PRIMING MODE (“RUN PMPS PURG AIR”). This
mode will last for 4 minutes before automacally
entering the normal operaon mode. See complete
details for your spa in secon HYDROPOOL
CONTROL SYSTEMS
UNIONS GATE VALVE
PROPER WATER LEVEL AT
SKIMMER OPENING