EasyManua.ls Logo

Hydropool SERENITY - General Troubleshooting; Power Fluctuations and Brown-Outs; Power Failure or System Faults

Hydropool SERENITY
39 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
37
GENERAL TROUBLESHOOTING
WHAT TO DO IN THE EVENT OF...
…POWER FLUCTUATIONS
The power supply into your home is, for the most part, fairly consistent. However, when local power demand is
high, there is a tendency for the voltage entering your home to drop (sometimes significantly) or fluctuate. This
condition is referred to as a ‘brown-out’. Although safeguards have been built into the system to protect against
this condition, supply voltage may drop low enough, if even for a second, to cause the system to display a ‘ghost’
message. Should this occur or if the display shows partial messages, try resetting the system by turning power
to the hot tub off, waiting a few minutes, then turning power on again. If this does not reset the system, contact
your local Hydropool retailer or service organization.
…POWER FAILURE OR SYSTEM FAULT DURING
COLD WEATHER CONDITIONS
If your control system will not reset, (ie. GFCI trips) or if your pump will not circulate for any other reason, place
a low wattage space heater under the cabinet in the equipment area. This will delay the risk of freezing while a
service appointment is scheduled.
Always follow the manufacturer’s instructions when locating and placing a portable
electric space heater into service. Ensure that safe clearance to combustible surfaces is
maintained. Do not leave unattended.
NOTES:
WINTER DRAIN PLUGS

Table of Contents

Related product manuals