Product overview
Before you can use the PSC2.400(d) in your
particular setup, you first have to set the right
settings. This is done by pc software, called
Hypex DSP filter design.
Please do not connect any speakers to your
system yet!
Hardware part
The PSC2.400 can be used in 2 ways, as a 2-
channel setup or as a one channel bridged
version for more power. This is selected in
software.
The module can store up to 4 presets. A preset
holds the complete filter-settings of both
channels. By this the user is able to make
different system settings for its speakers, for
example for different rooms and setups.
All of the presets are empty from factory
setup, therefore the filters must be downloaded
first. See section “examples”.
* note that for bridged mode both LS+
connections must be used, see section
Connections for more information
To Next Page
Loading...