What to do if my Hypontech Inverter displays a DC component of the current exceeds permissible range error?
Disconnect the inverter from the utility grid and the PV array, and reconnect it after the LED turns off. If the fault persists, further assistance is needed.
What should I do if my Hypontech Inverter reports that N and PE voltage exceeds permitted range?
Check if the inverter is securely grounded.
General| Max. DC Voltage | 1000 V |
|---|---|
| Number of MPPTs | 2 |
| Rated AC Power | 8000 W |
| Max. AC Power | 8800 VA |
| Rated AC Voltage | 230 V |
| AC Voltage Range | 180-280 V |
| THDi | <3% |
| DC Switch | Yes |
| Protection Degree | IP65 |
| Operating Temperature Range | -25°C to +60°C |
| Cooling | Natural Convection |
| Frequency | 50/60 Hz |
| MPPT Voltage Range | 200-800 V |
| Power Factor | 0.8 leading - 0.8 lagging |
| Output Voltage | 230 V |
| Efficiency | 98.2% |
| Protection Features | Overvoltage |
Outlines critical safety precautions to be followed before and during the commissioning process of the inverter.
A comprehensive checklist of safety checks to perform before energizing the inverter and starting operation.
Information on identifying and responding to an Earth Fault Alarm, including error code 6 and LED indication.
A guide listing all error codes, their descriptions, and recommended corrective actions for troubleshooting.
A critical safety warning regarding the high temperature of the heat sink during operation and cleaning precautions.
To Next Page