6
GENERAL SAFETY REQUIREMENTS
Please read all safety instructions before
using this appliance.
●
Ensure proper installation and
servicing to avoid voiding the product
warranty for improper installation.
This appliance must be properly
installed and grounded by a licensed
plumber or licensed electrician.
●
This appliance must be
repaired/serviced by a qualified
service technician- available through
our nationwide service networks of
professionals. Please call technical
support at 800-928-4693 x 2 if you
are in need of a repair after the
product has been properly installed
by a licensed plumber or electrician.
●
Read this use & care guide carefully
before using your new range to
reduce the risk of fire, electric shock
or injury.
●
Warranty service must be performed
by a qualified licensed appliance
technician: that has had experience
working on HypoTheory appliances.
●
Have the installer show you where
the fuse or electrical box is located in
your home. Learn how and where to
shut off the electricity to the range.
●
Always properly clean and maintain
the range as recommended in this
guide. Clean only those parts listed in
this guide. Do not use any rough
object (Brillo pad, etc. to clean
delicate metals to avoid damage).
●
Do not place cookware on range floor
or use aluminum foil or other material
to line the range floor or side walls.
Failure to adhere to this notice will
damage the range and will void your
warranty.
●
Always use dry pot holders when
removing pans from the range. Wet or
damp pot holders can cause steam
burns. Do not let pot holders touch
hot heating elements. Do not use a
towel or other bulky cloth.
●
Be sure that the range cool air intake
(located above the door) and range
exhaust vent (located below the door)
are unobstructed at all times.
●
Position range racks in desired
locations when range is cool. If a rack
must be repositioned after the range
is already hot, be certain pot holder
does not contact a hot heating
element in the range.
Safety Precautions/Instructions
www.hypotheory.com
To Next Page
Loading...