10
●
Gas Line Assembly: All gas
installation must be done by a
licensed plumber. The gas line is
located in the rear of the oven and
does not protrude out to allow the
oven to rest flush against the wall.
The gas line is a ½ inch threaded gas
pipe, there is a sample quick inlet
fitting that must be unscrewed &
replaced with a ½ inch female flare
fitting. Then a gas hose or a gas pipe
must be connected to the female
flare. (Accessories not included, can
be purchased in a home improvement
store/plumbing supply store)
HTDF366 – Affluent Series Range Installation
www.hypotheory.com
●
Converting to Natural Gas or
Liquid Propane.
1. Turn the knob to the maximum
position, and ensure the burner flame
is on.
2. Take off the knob by pulling
forward carefully, do not lose parts,
and use a screw driver to rotate the
screw in each gas valve.
3. Adjust the screw until the flame is
at the preferred height.
4. Please follow the instructions on
the next page to change the nozzles.
The nozzles must be changed first.
To Next Page
Loading...