Hyster D177 User Manual

0$='$ (1*,1(
M4-2.0G AND
M4-2.2G
H1.50-1.75
XM (S/H25-35XM)
[C010, D001
, D010, E001];
H2.00XMS (S
/H40XMS)
[C010, D001
, D010, E001]; S/H2.00-3.20XM
(S/H40-65X
M)
[D177, D18
7, H177]
PART NO. 897477 600 SRM 496

Hyster D177 Specifications

General

Brand	Hyster
Model	D177
Category	Forklifts
Language	English

Summary

Cylinder Head, Camshaft, and Valve Mechanism Repair

Crankshaft and Main Bearings Repair

Main Bearings

Specific inspection and repair procedures for main bearings.

Pistons and Connecting Rods Repair

Inspect and Repair

Covers inspection and repair of pistons and connecting rods.

Cylinder Block Repair

Oil Pump Repair

Inspect

Covers inspection of oil pump components and clearances.

Cooling System Repair

Thermostat

Procedures for replacing and testing the thermostat.

Fan Assembly

Steps for removing, disassembling, and assembling the fan assembly.

Flywheel and Ring Gear Repair S/H2.00-3.20XM (S/H40-65XM)

Ring Gear, Replace

Procedures for replacing the flywheel ring gear.

Flywheel Repair H1.50-175XM, H2.00XMS (S/H25-35XM, S/H40XMS)

Valve Adjustment

Valve Adjustment

Procedures for adjusting intake and exhaust valve clearances.

Compression Pressure Check

Compression Pressure Check

Steps for performing a compression pressure test on engine cylinders.

Engine Timing Adjustment

Engine Timing Adjustment

Troubleshooting

The engine will not start.

The engine does not run smoothly.

The engine does not have enough power.

There is noise inside the engine.

The engine gets too hot.