13
Transmitting a phone call:
1. Access the phone system.
● Live Dial
Hold down the PTT key, and enter the access code via the
palm microphone with keypad. Then release the PTT key. The
radio beeps and displays the dialing information. When the
phone system is accessed successfully, the radio goes to the
DTMF keypad mode.
● Buffer Dial
A. Enter the DTMF keypad mode. The following methods are
available to enter this mode.
● Go to “Menu -> Phone –> Manual Dial” to enter the DTMF
keypad mode.
● Press the programmed DTMF Keypad key.
● Go to “Menu -> Phone -> DTMF Keypad”, and then select
“Enable". The number entered via the palm microphone with
keypad in the home screen is the DTMF code.
B. Access the phone system: Enter the access code via the
palm microphone with keypad and then press the PTT key.
The radio beeps and displays the dialing information. When
the phone system is accessed successfully, the radio goes to
the DTMF keypad mode again.
2. Make the phone call.
● Live Dial: Hold down the PTT key and enter the phone
number via the palm microphone with keypad. Release the
PTT key after the complete number is entered.
● Buffer Dial: Enter the phone number via the palm microphone
with keypad and then hold down the PTT key.
Call
● Select “Back”. Then go to “Menu -> Phone ->Phone List” to
select a desired contact, and press the PTT key.
3. After the call is established, you can hold down the PTT key
to talk, and release it to listen.
To end the call, you can send the de-access code (the input
method is the same as that for the access code) to exit the phone
system.
If the phone is hung up, the call will be ended and the phone
system will be exited too.
Receiving a phone call:
● When the radio receives a phone call, the icon or
will appear.
● You may hold down the PTT key within the preset time period
to call back. If you do not respond to it, your radio will provide
appropriate indications. The indication information is the same
as that for the Private Call.
To Next Page
Loading...
Need help?
General
