4
1
2
3
3. Assembling the Belt Clip
4. Assembling the Accessories
1
2
Remove the screws Assemble the Belt Clip
Before Use
Charging the Battery
Please use the charger specified by the Company, and follows the
charging steps as shown below.
LED Indication Current Status
The LED Indicator ashes red slowly Standby (no load)
The LED Indicator glows red Charging
The LED Indicator glows orange
90%
90% charged
The LED Indicator ashes orange slowly Low current charging
The LED Indicator glows green
100%
Fully charged
The LED Indicator ashes red rapidly Charging error
●
Make sure the radio is powered off before charging.
Read the Safety Information Booklet in advance to get
necessary safety information.
●
To achieve optimal battery performance, please charge
the battery for at least 5 hours before initial use.
Charging the Radio
Charging the Battery
Do not swing the radio when holding it by the antenna,
so as to avoid lowering the performance and shortening
the life span of the antenna.
Caution
Caution