11
5. Fault Handling
Description Cause Analysis Solution
Power-On Failure
The battery is not properly
installed or in bad contact.
Check whether the
battery is correctly and
firmly installed is correct
and firm
Low battery.
Touch the battery display
button to check the
current battery level. In
case the battery runs out
of power, please charge
the battery first or
connect the external
power for power supply,
then try to power on.
Communication
failure between
E-pack100
The sending and receiving
frequency are not consistent
between E-pack100.
Check whether the
frequency is consistent,
and please contact
dealer to reset the device
if necessary.
The work frequency point is
disturbed by strong signal and
unable to transmit useful
signal.
Find the interference
source, and if unable to
shut down or stay away
from it, please apply for
To Next Page
Loading...
