Hytera MNC360 - System Settings; Wlan; Pairing with a BT Accessory; Unpairing a BT Accessory

System Settings
User Manual
10
6. System Settings
Press the
Navigation
key to select
Settings
, press the
OK
key, and then set the following radio parameters.
6.1 WLAN
After the radio connects to WLAN, you can access the Internet.
Press the OK key twice to enable the WLAN.
Press the Navigation key to select an available WLAN in the list, and then press the OK key.
(Optional) If a password is required, enter the password, press the Navigation key to select Done, and then press
the OK key.
The radio saves WLAN information after successful connection.
6.2 BT
The BT feature allows you to transmit voice through wireless earpiece or remote speaker microphone.
6.2.1 Pairing with a BT Accessory
Press the Navigation key to select BT, and then press the OK key twice to enable the BT.
Press the Navigation key to select the device from the Available devices list.
Press the OK key.
The
Pair with xxx
? dialog box appears. xxx indicates the BT device name.
Press the OK key again to pair with the device.
6.2.2 Unpairing a BT Accessory
Enable the BT.
For details, see step 1 in 6.2.1 Pairing with a BT .
Press the Navigation key to select the device from the Paired devices list, and then press the OK key twice to
disconnect from the device.
6.2.3 Modifying a BT Accessory Name
You can rename the BT accessory for easier identification.
Press the Navigation key to select Device name, and then press the OK key.
Enter the device name.