Hytera PD-795 Ex - 2-Tone

signaling when receiving any matched one.
During decoding , the LED glows green . After
successful decoding, the LCD displays the contact
information (or " Five Tone Call") , an appropriate call
icon (Private Call: ;. !., ~ ; Group Call: s L ~ ), and the
decoded status message. If Auto Reset is enabled
(by your dealer), your radio wi ll enter the Auto Reset
mode, with LED
glowing orange, until the Auto Reset
Time expires.
2-Tone
With this signaling, the radio can transmit and receive
2-Tone
calls.
Encoding:
1. Request your
dealer to configure the correct format
and type for the encoding contents.
2. Press PTT key
or the programmed One Touch
Call 1-0ne Touch Call 5 keys to send the 5-Tone
signaling.
During encoding , the radio sounds a side tone, the
LED
glows red, and the LCD displays the call icon
:. t '"'"i> with contact information above it. If Auto Reset
is
enabled (by your dealer), your radio will enter the
Auto Reset mode after
successful encodi ng , with LED
glowing orange, until the Auto Reset Time expires.
Decoding:
Your radio can automatically decode the 2-Tone
signaling when receiving any matched one.
During decoding, the LED glows green . After
successful decoding, the LCD displays the call icon
. ~ L ~ and the call type (selective call , alert call
w/voice , alert call) below the icon according the
decoding type.
If Auto Reset is enabled (by your dealer), your radio
will enter the Auto Reset mode, with LED glow ing
orange, until the Auto Reset Time expires. The radio
cannot enter the Auto Reset mode
if it is an alert call.
17