Attaching the Antenna
Do not hold the radio by the antenna, because it may reduce the radio
performance and life span of the antenna.
Attaching the Belt Clip
1. Use a Phillips screwdriver to turn the screws counter-clockwise on the
back of the radio and remove them.
2. Align the screw holes on the belt clip with those on the back of the
radio.
3. Put the screws back in place as shown below, and use the Phillips
screwdriver to turn them clockwise until hand tight.
Attaching the Audio Accessory
For optimal waterproof and dustproof performance, close the
accessory connector cover and fasten the screw when no accessory is
attached.
1. Open the accessory connector cover.
2. Plug the accessory into the accessory connector.
6
To Next Page
Loading...
Need help?
General
