Roam
The Roam feature allows you to enjoy seamless communication across sites
or networks.
To turn on or off this feature, press the OK/Menu key, go to Roam > Roam
On/Off, and then select On or Off.
To select a roam list, press the OK/Menu key, go to Roam > Roam List,
and then select the required list.
Analog Services
Turning On or Off the Squelch Off Feature
The Squelch Off feature allows the radio's speaker to keep turned on no
matter whether the squelch condition is satisfied.
To turn on this feature, press the preprogrammed Squelch Off key or press
and hold the preprogrammed Squelch Off Momentary key.
To turn off this feature, press the preprogrammed Squelch Off key again or
release the preprogrammed Squelch Off Momentary key.
Setting the Squelch Level
The squelch level refers to the squelch threshold required for the radio's
speaker to be turned on.
To set the squelch level, do one of the following:
l Press the OK/Menu key, go to Settings > Radio Set > Squelch, and then
select Open, Normal, or Tight (from low to high) as required.
l Press the programmed Setting the Squelch Level Key.
Generally, a higher squelch level requires higher signal strength. If the
squelch level is set to Open, the speaker will always keep turned on.
Turning On or Off the Monitor Feature
The Monitor feature allows the radio to receive weak signals.
To turn on or off this feature, press the preprogrammed Monitor key.
Setting the CTCSS/CDCSS Feature
The Continuous Tone-Coded Squelch System (CTCSS)/Continuous Digital-
Coded Squelch System (CDCSS) feature allows the radio to filter out
unwanted voice on the current channel.
You can request your dealer to enable this feature.
16
To Next Page
Loading...
Need help?
General
