Hytera RD980 - After-Upgrade Check; Rd98 X

Upgrade Guide
Upgrade and Check
11
2. Select the serial number of the repeater to be restored, and click “Restore” again.
If the serial number is not available, do not click “Restore”.
Step 5 A prompt box as shown below appears upon successful upgrade.
If no prompt appears, please try the upgrade again by restarting the repeater and entering the
download mode.
Step 6 Click “OK” and power off the repeater.
3.3 After-upgrade Check
Check whether the upgrade is successful.
3.3.1 RD98X
As LCD is designed for RD98X, the firmware information can be checked not only via the CPS of
V7.06.02.006 but also via the repeater menu which you can do as follows:
Step 1 Power on the repeater.
Step 2 Press the Navigation Knob to enter the main menu.
Step 3 Rotate the Navigation Knob to select “Radio Info”.