Hytorc LION GUN - Bolting with the Hytorc Nut

LION GUN® Electric Torque Tool Operations Manual
28
• The LION GUN Electric Torque Tool is easily configured
for tightening the HYTORC Nut.
• Identify the appropriate size HYTORC Nut Driver.
• Slide the nut driver over the square drive and spline
while aligning the set screw with the flat on the spline.
• Tighten the set screw to secure Nut Driver.
• Challenge the nut driver to make sure it is
• securely attached.
INSTALL THE HYTORC NUT DRIVER
. BOLTING WITH THE HYTORC NUT