6 CHANGING THE SOUNDS
On the supplied microSD are provided customized sound effects for a several number of trucks.
Note: To fully enjoy the sound quality it is recommended to use the original Tamiya
tm
speaker's or
a speaker of good quality available from your local dealer.
To select the set of sounds appropriate for the truck on which is installed the IBU2, do the
following:
1. With power OFF, press lightly on the microSD inserted under the IBU2 to release the microSD
memory card (NOTE: DO NOT PULL THE MICROSD TO UNLOCK !!!), pull it out and insert into a
memory card reader (not supplied) on your PC, MAC.
2. Access the media and browse its contents.
3. In the root of the media are the files used by the sound module of IBU2.
Each wave file is associated with a different sound effect according to the correspondence
set in the file "IBU2_TR.INI":
Variable in the file IBU2_TR.ini Es. Audio file Corresponding effect
Engine Cold ON estartc.wav Starting a cold engine
Engine Warm ON estartw.wav Starting the engine hot
Engine Stop estop.wav Engine stop
Engine Idle eidle.wav Engine idling
Engine Step 1 es01.wav Motor Ramp 1
Engine Step 2 es02.wav Motor Ramp 2
...
Engine Step XX esXX.wav Motor Ramp XX
Revup revup.wav acceleration
Revdw revdw.wav deceleration
Airblast1 airbst1.wav 1 air vent
Airblast2 airbst2.wav Air vent 2
Airblast3 airbst3.wav Air vent 3
Airblast4 airbst4.wav Air vent 4
AlarmRev alarmrev.wav Reverse Alarm
AlarmBatt alarmb.wav Battery Alarm
Brake brake.wav braking
Dryer dryer.wav air vent dryer
Horn1 horn1.wav Clacson1
Horn2 horn2.wav Clacson2
Latch latch.wav trailer coupling
Unlatch unlatch.wav release trailer
Shift1 horn1.wav Clacson1
Shift2 horn2.wav Clacson2
Turn1 turn1.wav indicator 1
Turn2 turn2.wav indicator 2
To Next Page
Loading...