7 CONFIGURATION SETTINGS "IBU2_TR.INI"
In addition to the associations of the sound effects with the corresponding wave file, into the text
file IBU2_TR.INI there are other variables that allow you to customize certain features of your IBU2
Truck.
Configuring the reverse channel radio
Each line refers to a specific channel receiver, this function is used, if you are using an older radio
(without memory), to avoid having to set (if necessary) the reverse channels depending on the
truck that are using
RadioCH1InverseCmd = FALSE; TRUE / FALSE
RadioCH2InverseCmd = FALSE; TRUE / FALSE
RadioCH3InverseCmd = FALSE; TRUE / FALSE
RadioCH4InverseCmd = FALSE; TRUE / FALSE
In this example, all channels have value FALSE this means that no channel is applied on the
inversion, or the commands that arrive from the transmitter are reported to the decoding circuit
so as sent.
Configuring the reverse servo
If needed, you can reverse the direction of rotation of the servos, each line is related to a specific
channel, and this function is used as different manufactured servos turn in opperstie direct. This
will be truck specific.
The line:
SteerInverseCmd = FALSE; TRUE / FALSE allows you to reverse the steering control
The line:
TrailInverseCmd = FALSE;TRUE / FALSE allows to invert the command of latch/unlatch the trailer
The line:
ShiftInverseCmd = FALSE; TRUE / FALSE allows you to reverse the command of the gear shift
In this example, all channels have value FALSE this means that no channel is applied on the
inversion.
Configuring the front and rear lights
The parameter is used to configure the state of the headlights at truck power on
HeadlightInitialStatus = 1; [0 OFF - 1 ON]
In this case, the lights will be turned on at power on, by entering the value 0 (zero) the truck will
start with the lights off.
(The lights can be turned on or off even from the transmitter, see chapter 5 Controls)
To Next Page
Loading...