ASSEMBLY FOR BICYCLES WITHOUT THREADED BUSHES
If your bike does not have threaded bushes for mounting
I LOCK IT Pro, then I LOCK IT Pro can
be mounted
easily and
securely with
the optionally available installation adapters.
To do this, carry out the following steps:
The installation adapters have flexible screw mounts
that can be adjusted laterally.
This allows even more leeway in the frame width of
the bike.
I.
Attach the appropriate installation adapter to one of
the frame struts.
II.
Guide the plastic straps (1) around the strut and then
through the openings on the installation adapter.
III.
Insert the plastic screws into the installation adapter.
IV.
Use a suitable screwdriver to tighten the installation
adapter by turning the plastic screw.
To Next Page
Loading...