OPERATION
Briefly pressing the key fob button establishes a connection
between the key fob and the configured
I LOCK IT Pro (if within range). As soon as the connection is
established, the key fob LED lights up blue for 5 seconds and an
opening or locking process takes place immediately.
When leaving the Bluetooth range (e.g. after parking and leaving
the bike), the connection is disconnected and the key fob
switches to energy-saving mode.
After pressing the key fob button, the LED
lights up blue and a short confirmation tone is
emitted. This indicates that a command has
been sent to I LOCK IT Pro. The command can
only be transmitted if I LOCK IT Pro is within
range.
DEACTIVATE ALARM
If the audible alarm of your I LOCK IT Pro is triggered and
there is a connection to the key fob, the key fob LED starts
to flash red. The audible alarm can be deactivated before
the 30 seconds have elapsed by briefly pressing the key fob
button.
To Next Page
Loading...