RESTORE
FACTORY SETTINGS
If the key fob is reset to factory settings, the connection
between I LOCK IT Pro and the key fob is deleted. The key fob
can then be connected to a new I LOCK IT Pro.
The following steps must be carried out to reset the key fob to
the factory settings:
I.
Open the battery cover and remove the battery.
II.
Press and hold the key fob button.
III.
Reinsert the battery in the key fob (keep the button
pressed).
IV.
Release the key fob button after approx. 5 seconds.
If the key fob LED flashes blue, the process was successful and the
key fob has been reset to the factory settings.
To reconnect the key fob to an I LOCK IT, the
initial setup must be carried out again.
To Next Page
Loading...