IAME NORSWIFT 60cc - User Manual

0
 
MAN - 099 - EN

IAME NORSWIFT 60cc Specifications

General

Brand	IAME
Model	NORSWIFT 60cc
Category	Engine
Language	English

Summary

Feeding

Engine Mount Preparation

Drill 4 holes Ø8.25÷8.5mm (Ø13.5÷14mm counterbore) for engine mount preparation as per drawing.

Electrical Plant

Warning on the Exhaust Plant

Check muffler mounting springs. Replace broken springs. Clean counter-cup holes every 10/15 hours.

Warning on the Inlet Silencer

Ensure inlet silencer faces up, is unobstructed, and clamp is tight. Clean internally.

Cadetti Class Carburettor Setting

Tillotson HW-47 A Carburettor Setting

Recommended base setup for HW-47A carburetor: L 1 turn+15′-1 turn+30′, H 30′-40′. Adjust for conditions.

Mini Class Carburettor Setting

Tillotson HW-34 B Carburettor Setting

Recommended base setup for HW-34B carburetor: L 1 turn+30′-1 turn+40′, H 40′-50′. Adjust for conditions.

Correct Installation of the Ignition Coil Onto the Crankcase

Main Components Parameters and Estimated Lifetime

Cylinder;Piston Pairing

Replace piston every 100 liters or if tolerance exceeds 0.11mm. Check clearance at 15mm from base.

Con Rod Small End Roller Cage

Recommended replacement after approximately 100 liters of use.

Crankshaft, Con Rod Big End Cage, Crank Pin, Washers

Recommended replacement after 200 liters of use.

Main Roller Bearings

Recommended replacement after 200 liters of use.

Con Rod

Recommended replacement after 400 liters of use; check roundness of big end hole.