iBaby MonitorUser Manual
Answer: Red indicates that iBaby is not connected to your WI-FI. The solution is
as follows:
1) Please use the USB cable that comes with the original phone to ensure good
transmission.
2) Please install iBaby in a place with good WI-FI signal. The WI-FI name and
password are preferably 8-32 characters in upper and lower case letters, numbers,
- or underscores. They cannot contain special characters (such as Chinese
characters, Japanese). , Korean, etc.).
3) The SSID broadcast on the router should be turned on.
4) WPA2-PSK is selected for the WI-FI authentication type on the router, and AES
is selected for the encryption algorithm.
Question 2Android users:
Prompt installation failed, the LED status light behind iBaby flashes red, what is
the reason?
To Next Page
Loading...
