IBM 31P6240 - Your New Monitor; Connecting Your Monitor

English - 2
Connecting Your Monitor
1
Turn off your computer and unplug the
power cord.
2
Signal cable
Connect the end of the signal cable to
your computer’s video port (Video board,
video card, or graphics card).
3
Power port
Connect the power cord for your monitor
to the power port on the back of the
monitor.
4
Power cords
Plug the power cord for the monitor and
the power cord for your computer into a
nearby outlet.
5
Turn on your computer and monitor.
If your monitor displays an image,
installation is complete.
6
Install monitor driver
• Insert the provided diskette into the A:
drive, when prompted by the operating
system.
3
2
4
Your New Monitor
Kerr15_main_1.fm Page 2 Wednesday, September 5, 2001 6:16 PM