IBM 3270 - Page 59

The parts of the Send command are:
.., SEND
e d:
e path
The name of the command .
(You
always need this name.)
The diskette or fixed disk drive
on which the file you want to
send is located: a, b, c, or d. (If
the file to be sent and the
utilities are on separate
diskettes, this part must name
drive B. If, in addition, you
have only one diskette drive
and you are told to insert a
diskette into drive B, insert it
into drive A instead. If the file
to be sent and the utilities are
on your fixed disk or on the
same diskette, this part is
optional.)
The subdirectories that the file
is in.
(Include this part only if
the file is in a subdirectory.)
e filename.ext The name of the file you want
• h:
o fnftfm
to send. (Include the extension
if the file has one.)
The short name of the window
that contains the VMjCMS
host to which you want to send
the file. (This part is optional,
if you have only one host.)
The name that the file is to
have on your CMS disk. (You
need the filename, filetype, and
filemode. You can make up a
new name or name a file that
is already on your CMS disk.
If you use a new name, the file
tha t you send will be added to
your CMS disk. If you use the
7 -6 Book 3 - Using the Control Program