IBM 3270 - Page 58

8. Press the Enter key, and this message will
appear:
INDFT001 File transfer command being processed
INDFT002 Number of bytes of file transferred so far: ==> xxxxxx
9. Wait until you see this message:
INDFT003 File transfer complete
That's all there is to it. You can now go to your
VM/CMS host session and find the file you sent.
How to Write the SEND Command
There are several parts to the SEND command.
" 0 •
•
•
•
SEND d: path filename.ext h:fn ft fm
•
•
r A. " ~~
(ASCII CRLF APPEND LRECL n RECFM x)
If you need the parts shown in upper case, type
them exactly as shown. If you need the parts
shown in lower case, you must supply you own
names or values. The parts between the
parentheses are optional.
Sending Files Between a PC and a Host 7-5