Chapter 3. Removal and installation procedures for the
4810/4910 SurePOS 300
This section describes how to remove and install the components of Model x4x of
the 4810/4910 SurePOS 300. These are the procedures that are included:
v “Removing and installing the top cover” on page 12
v “Removing and installing the hard disk drive” on page 14
v “Removing and installing the hard disk drive and hard disk tray as an assembly”
on page 15
v “Removing and installing the flash drive” on page 16
v “Removing and installing the memory module” on page 17
v “Removing and installing the front-panel card” on page 18
v “Removing and installing the I/O connector card” on page 19
v “Removing and installing the riser card and the I/O connector card as an
assembly” on page 20
v “Resetting the system board CMOS settings” on page 23
v “Removing and installing the power supply” on page 21
v “Removing and installing the hard disk drive air duct” on page 22
v “Removing and installing the battery” on page 23
v “Removing and installing the system board” on page 25
v “Removing and installing the front cover” on page 27
March 2009
© Copyright IBM Corp. 2005, 2009 11
To Next Page
Loading...
