IBM 4810-E3H - Removing and Installing the Front-Panel Card; Removing and Replacing the Front-Panel Card

Removing and installing the front-panel card
To remove the front-panel card:
1. Open the unit. See “Removing and installing the top cover” on page 12.
2. Remove the hard drive and tray assembly. See “Removing and installing the
hard disk drive and hard disk tray as an assembly” on page 15.
3. Disconnect the front-panel card cable1 from the system board .
4. Remove the two screws2 that attach the front-panel card assembly to the
front cover.
5. Slide the front-panel card assembly out.
6. To replace the front-panel card assembly, reverse this procedure.
1
2
Figure 14. Removing and replacing the front-panel card
March 2009
18 SurePOS Installation and Service