Figures
1. Dimensions of the 4810/4910 SurePOS 300 .....................3
2. Front view of 4810/4910 system unit ........................5
3. Rear view of the 4810/4910 model x4x (RS232) ....................6
4. Rear view of the 4810/4910 model x4x (USB) ....................6
5. Removing and installing the top cover .......................12
6. Service label ................................13
7. Removing the hard disk drive ..........................14
8. Removing the hard drive and hard drive tray as an assembly ..............15
9. Removing the flash drive ............................16
10. Opening the memory-module retainer clips .....................17
11. Memory-module retainer clips in the open position. ..................17
12. Installing the memory module ..........................17
13. Closing the memory-module retainer clips .....................17
14. Removing and replacing the front-panel card ....................18
15. Removing the I/O connector card .........................19
16. Removing the riser card and the I/O connector card as an assembly............20
17. Removing the power supply ...........................21
18. Removing the hard drive air duct .........................22
19. Locating and resetting the CMOS jumper ......................23
20. Removing and installing the battery ........................24
21. Removing the system board...........................25
22. Tilting and removing the system board .......................26
23. Removing the front cover............................27
24. Keyboard/Mouse Connector ...........................43
25. RS232 Connector ..............................44
26. Powered RS232 Connector ...........................45
27. External VGA Connector ............................46
28. Ethernet Connection .............................47
29. USB Connector ...............................47
30. Cash Drawer Connector ............................48
31. Powered USB Connector ............................49
March 2009
© Copyright IBM Corp. 2005, 2009 vii