IBM 4810-E3H - Removing and Installing the Front Cover

Removing and installing the front cover
To remove the front cover:
1. Open the unit. See “Removing and installing the top cover” on page 12.
2. Remove the hard drive assembly. See “Removing and installing the hard disk
drive and hard disk tray as an assembly” on page 15.
3. Release the bottom two retaining tabs2 one at a time, applying pressure to
separate the front cover from the chassis.
4. Release the top three retaining tabs1 one at a time, and slide the cover to the
right 3 to separate the front cover from the chassis.
5. Unsnap the sixth retaining tab as you move the front cover toward the right 3.
To install the front panel:
1. Align all five of the front panel retainers.
2. Push the front panel toward the chassis and snap into position.
2
1
3
Figure 23. Removing the front cover
March 2009
Chapter 3. Removal and installation procedures for the 4810/4910 SurePOS 300 27