IBM 4810-E3H - Removing and Installing the Flash Drive; Removing the

Removing and installing the flash drive
To remove the flash drive or to access the system board to install a flash drive:
1. Open the unit. See “Removing and installing the top cover” on page 12.
2. If present, remove the hard drive tray assembly. See “Removing and installing
the hard disk drive and hard disk tray as an assembly” on page 15.
3. To remove the flash drive, gently lift the flash drive1 straight up and off the
white plastic guide pin2.
To replace or install a flash drive:
1. Align the flash drive 1 with the white plastic guide pin2 and with the
connectors on the system board. Push down until the flash drive is seated.
2. Replace the hard drive tray assembly. See “Removing and installing the hard
disk drive and hard disk tray as an assembly” on page 15
3. Replace the top cover. See “Removing and installing the top cover” on page 12.
1
2
Figure 9. Removing the flash drive
March 2009
16 SurePOS Installation and Service