IBM AS/400

Control Panel
Warning: The control panel is sensitive to
electrostatic discharge. See Appendix A,
"Working with Electrostatic Discharge-Sensitive
Parts"
on page A-1.
1 Power off the system. See Powering Off
the System in Chapter 3, "Service Refer-
enced Procedures" on page 3-1.
2 Disconnect the power cord.
3 Remove the front and top covers. See
"Covers"
on page 1-10.
1-8 AS/400 940219404 Models 2xx Repair and Parts
4 Remove the screws m.
5 Pull the control panel assembly from the
frame.
6 Disconnect the control panel cable from the
control panel assembly.
7 Remove the screw iii to remove the bezel
assembly
II from the circuit card
assembly
m.
8 Install the control panel assembly by
reversing the removal procedure.
This ends the procedure.