28 Brocade 2-Port 10GbE Converged Network Adapter for IBM BladeCenter Installation and User’s Guide
Installing the device drivers and HCM
3
4. When the License Agreement screen displays, select I accept the terms of the License
Agreement, then click Next to continue.
5. If a backup directory exists for previously installed software, a “Found Backed up data”
message displays prompting you to restore old configurations. Select either to restore or not to
restore and continue installation. If this message does not display, go on to step 6.
6. If a screen displays listing existing software components already installed on your system,
select either of the following options, click Continue, then skip to step step 10. If this message
does not display, go on to step 7.
• Install with existing configuration. The installer compares each configured property and
keeps the original value if different than the default value.
• Install with default configuration. The installer upgrades the software and loads with
default configurations.
Existing versions of the software components will be overwritten with the current versions
you are installing if you continue.
7. If a message displays prompting you to close HCM, close the application if it is running, then
click OK on the message box.
The Choose Install Set screen displays.
8. Select which software you want to install, then click Next.
9. If the Choose Install Folder screen displays, prompting you to choose a destination folder for
the software, select either of the following options. If this screen does not display, go on to
step 10.
• Enter a location for installing the software.
• Select Choose to browse to a location on your file system.
• Select Restore Default Folder to enter the default installation folder.
10. When the Package Location Information screen displays listing the installed software
components and their location on your system, click Next to continue.
11. Review information on the Pre-Installation Summary screen and click Install to begin installation.
A dialog box displays showing installation progress.
For Windows systems, a Force Driver Installation message box displays if a better driver is
already installed for the adapter. If a message displays, select OK to overwrite the existing
driver or Cancel to quit installation.
12. Click Done when the Install Complete screen displays to confirm installation.
13. If a message or screen displays instructing you to restart or reboot the system, perform the
action indicated.
14. Verify driver installation through tools available on your host system. Refer to the “Confirming
driver package installation” section in the “Software Installation” chapter of the Brocade
Adapters Installation and Reference Manual for details.
To Next Page
Loading...
Need help?
General
