C.1 How to Install the EMS Memory Manager
The section describes how to install the EMS memory manager.
1. Insert the backup copy of the Reference Diskette into the diskette
drive.
2. At the DOS prompt, type COPY A:\MM.SYS C:\ and press Enter.
3. Edit the CONFIG.SYS file using EDLIN.COM or other editor programs.
The format and explanation of parameters and values are shown below.
Subtopics
C.1.1 Format:
PS/2 Model L40 SX Quick Reference
How to Install the EMS Memory Manager
¦ Copyright IBM Corp. 1991
C.1 - 1
To Next Page
Loading...
