IBM L40 SX - E.5.2 Installing the Parallel Connector Setup Program for

To Next Page

To Previous Page

#E.5 Parallel Connector Setup Program

#After POR (power-on reset), by default, the parallel connector of the

#Model L40 SX is set to extended mode that allows bidirectional input and

#output. However, some parallel devices do not work in extended mode. The

#parallel connector setup program resets extended mode so such parallel

#devices can work. The programs both for DOS and OS/2 are available on the

#Reference Diskette.

Subtopics

E.5.1 Installing the Parallel Connector Setup Program for DOS

E.5.2 Installing the Parallel Connector Setup Program for OS/2

PS/2 Model L40 SX Quick Reference

Parallel Connector Setup Program

E.5 - 1

Other manuals for IBM L40 SX